Axxess AX-ADDCAM-FD1 Ford Plug and Play Harness for AX-ADDCAM Interface
Suitable for vehicles with 8 (SYNC 3) Some vehicles may still require a reverse trigger into the AX-ADDCAM module when using this product. Requires AX-ADDCAM module to be used. Save time with your installation and messy looms with the AX-ADDCAM-FD1 from Axxess Interfaces. Product Compatibility Information Plug & Play : Yes Requires AX-ADDCAM Module Will It Retain Factory Reverse Camera? : YES Included With Interface Vehicle Make Vehicle Model Vehicle Year + Vehicle Chassis Code FORD ESCAPE 2016 - 2018 (ZG) FORD EVEREST 2015 - 2016 (UA) FORD F SERIES 2015 - 2019 (13th Gen) FORD FOCUS (Incl XR5) 2016 - 2018 (LW) FORD MONDEO 2015 - 2019 (MD) FORD MUSTANG 2015 - 2017 (6
TH GEN) FORD RANGER 2015 - 2018 (PX2). The AX-ADDCAMFD1 Allows integration of the AXXESS ADD CAM interface to your Ford Vehicle fitted with the SYNC3 system.
Tags: Axxess AX-ADDCAM-FD1 Ford Plug and Play Harness for AX-ADDCAM Interface
More products in category..
Some OEM sources / headunits have a test circuit that monitors the presence of a lowimpedance load to enable audio outputs ) 90 / 0 If there is a need to generate a remote signal to control the amplifier turn on / off, it is necessary to power the USS4, providing the additional feature of the possibility to delay the signal from 1 to 8 seconds, so as to avoid annoying bumps upon ignition...
The cable is 450 cm long to reach the vehicle boot, where the Audison Prima AP bit amplifier is installed The T connection type allows the user to separately route the signal to the front midwoofer housed in the car door and to the sub underneath the seat, without the need to cut the OEM cables...